Author |
Message |
Tim Stewart
New member Username: Tim_stewart
Post Number: 2 Registered: 10-2008
| Posted on Thursday, October 17, 2013 - 01:29 pm: |
|
CHECK PA INSPECTION REGULATIONS REMEMBER THE KEY WORD IS (WITHIN) |
Carl Souder
New member Username: Carl_souder
Post Number: 123 Registered: 02-2006
| Posted on Thursday, October 17, 2013 - 09:27 am: |
|
Yes all cutaway vehicles exit on the drivers side, but DOT is measuring the distance that the exhaust pipe exits in relation to the rear of the vehicle body not the distance from the bumper see attached. We had new buses written up. |
Dan_russell
New member Username: Dan_russell
Post Number: 89 Registered: 05-2005
| Posted on Thursday, October 17, 2013 - 08:56 am: |
|
Carl, All of our vans exit out the drivers side as Red Rose vans. Dan |
Dennis Chronister
New member Username: Dennis_chronister
Post Number: 36 Registered: 03-2009
| Posted on Thursday, October 17, 2013 - 08:55 am: |
|
I seem to recall discussing this in detail at one of the spec meetings. This is the way it's worded in the contract: "The exhaust shall exit on the driver’s side of each vehicle behind the rear wheels within 6” of rear bumper." It is a little vague as to which side of the bumper the exhaust is located at, but what maufacturer would extend it beyond the rear bumper? |
Randy_flyte
New member Username: Randy_flyte
Post Number: 19 Registered: 05-2005
| Posted on Thursday, October 17, 2013 - 08:34 am: |
|
Carl, All of the LANta vans exhaust pipes exit on the left side before the bumper. the same as Red Rose's. Randy |
Steve Myers
Member Username: Steve_myers
Post Number: 147 Registered: 08-2004
| Posted on Thursday, October 17, 2013 - 08:30 am: |
|
Carl, All of our vans exit out the left rear corner before the bumper.
|
Carl Souder
New member Username: Carl_souder
Post Number: 122 Registered: 02-2006
| Posted on Thursday, October 17, 2013 - 08:16 am: |
|
Has anyone had their cutaways inspected by DOT? Ours were inspected and they are writing up the exhaust the way it comes from the factory. It is supposed to exit 6 inches from the rear of the body not the rear of the bumper.We will need to address this in the spec....Carl |